Use of filtered detector audio that is unaffected by the local volume control.ģ) Short transistor Q27 E-C on TX/RX PCB to defeat the front-panel power switch. Interface Cable Pinout Diagram & Configuration Instructionsġ) Install KCT-19 Accessory Cable Assembly, in accordance with service manual instructions.Ģ) Cut Pin 1 wire (BRN) on KCT-19 8-pin sub-connector D (CN4), splice an extension wire to theĪccessory/peripheral side, and solder to CN1 pin 11 (designated AFO) on TX/RX PCB. KENWOOD TK-圆0 G-Series CPI TTP1 Tone-Termination Panel If tone, here's a document-you also didn't say if they were 760G or just 760.at any rate, this sheet ought to get you started in the right direction. You didn't mention whether you plan to use tone or DC termination, or an IRim box.
0 kommentar(er)
